2002 Chevrolet Trail_Blazer Radio / Car Audio Installation Guide
I
want to replace my factory radio
The parts in this section is what is
typically required for proper car audio / stereo installation
of most all replacement radios. Most car audio / stereo installation
kit can mount Shaft or Single Din (standard size) replacement
radios / car stereos.
I
have a "PREMIUM SOUND RADIO" and I would like to install a new
radio.
OEM-1 Kit
Select radio type
OEM-1 Kit
Price $
80.00
These kit are designed to plug directly
into your new radio* and your cars factory harness with out
making any crimps, soldering or taping wires together. It
is as easy as plugging a lamp in. No kidding if you can plug
a house lamp in you can wire your new radio. All you need
to do is plug the two supplied cords into the OEM1 then plug
the one end marked radio into your new CD or Cassette player,
and plug the other end into the cord that was plugged into
the back of your factory radio and your done. These also work
great on factory premium systems that tend to pop when turned
on and off. Installation time approximately two minutes, after
factory radio has been removed. * Must have radio from named
manufacturer and pin quantity or connections will be required
These are sold as complete kit with everything you'll need
I
want to 'Add an amplifier' to my factory radio
OEM-1 Kit
Price $
80.00
These kit are designed to plug directly
in between your factory radio and factory harness with out
making any crimps, soldering or taping wires together. The
adjustable OEM 1 (supplied) will have front and rear stereo
outputs (RCA'S) allowing up to two amplifiers to be added.
The OEM 1 will also have an output for the amplifier turn
on lead. Installation time approximately two minutes after
factory radio has been removed
Line Output Converters
SNI-35 Line Output
Converter
Price $
29.95
The model SNI-35 is used
to add an amplifier to a stereo which has speaker level outputs,
perfect for your next car audio / stereo installation
SNI-35 adjusts the signal from 2 to
40 watts per channel. Signals below 20Hz cutoff. Linear from
20-20,000Hz at +/- 5 dB, while maintaining signal phase. Isolates
input and output circuits to prevent ground loop noise. Perfect
when adding an amplifier to a factory or aftermarket radio.
Great for getting an additional set of pre-amps outputs from
a head unit equipped with only one set.
LN-60 Line Output
Converter
Price $
14.88
High Level to RCA Level
Adapter
Converts High Level Speaker Output
to RCA. Line Level/Adjustable Level Control. Sleek Black Color.
Allows the Easy Installation of EQ's & Amplifiers to Systems
with No RCA Outputs
Factory Parts & Accessories
Antenna Adapter
Price $
9.99
Antenna Adapter will plug
into the radio that came in the car when it was new
If your vehicle has
Steering Wheel
controls and you would like to replace your radio
with a new one, and still be able to use some of the functions
on the steering wheel.
Amplifier Tips
SNI-1 Noise Filter
Price $
19.95
The model SNI-1 is used
to remove noise from an amplifier outputs. Perfect for your next
car audio / stereo installation
*kit and harnesses may be substituted by another manufacture if
Metra product is not in stock
Tune-Town Car Audio
2345 E Perkins Ave
Sandusky, Ohio 44870
419-627-0065
Installation
Service
Sales
Support
Tune-Town is a registered Trademark All Rights Reserved. Tune-Town
cannot be responsible for errors published online. Some information
published has been provided by manufacture's and or corporations.
Tune-Town tries to maintain accuracy. Tune-Town recognizes all manufacture's
trademarks and or trade names herein and disclaims any proprietary
interest in their use.