|
|
|
This is a 7000 page project:
Please donate today |
2000 VOLVO V70 4DR WAGON
Security
Battery RED + (+) IGNITION SWITCH HARNESS Ignition BLU/RED (+) IGNITION HARNESS
Starter01 YEL/WHT + (+) IGNITION SWITCH HARNESS AllDoorTrigger PNK/BLK (-) KEYLESS MODULE ABOVE HOOD RELEASE * TrunkTrigger BLU/BRN - (-) MODULE LEFT OF STEERING COLUMN FactoryAlarmDisarm DISARMS WITH UNLOCK FactoryAlarmArm ARMS WITH LOCK
ParkingLights WHT + (+) HEADKIGHT SWITCH
Remote Start
Battery RED + (+) IGNITION SWITCH HARNESS Ignition BLU/RED (+) IGNITION HARNESS Ignition02 BLU/RED + (+) OR YEL IGNITION SWITCH HARNESS Accessory01 YEL/VIO + (+) SAME LOCATION AS ING WIRE
Starter01 YEL/WHT + (+) IGNITION SWITCH HARNESS AntiTheftType RF ACTIVATED SYS. AntiTheftSystem TRANSPONDER Tach BLU - (AC) AT COIL OR NEG SIDE OF INJECTOR GRY/RED
ParkingLights WHT + (+) HEADKIGHT SWITCH BrakeLights YEL + (+) AT BRAKE SWITCH
Doorlocks / Window
PowerUnLock GRY/RED - (-) PLUGS (DOUBLE PULSE TO UNLOCK ) PowerLock YEL/GRY - (-) KEYLESS MOD ABOVE HOOD REL. BLK BOX 2 GR DriverDoorMotor01 BLU/BRN - (-) AT DOOR MODULE DriverDoorMotor02 YEL - (-) AT DOOR MODULE PassengerDoorMotor01 YEL/BRN - AT DOOR MODULE LeftFrontWindow01 LF:GRN/BLU RE RightFrontWindow01 RF:WHT/BLU LR:GRN/GRY RR:GRN/WHT LeftRearWindow01 LF:GRN REV RightRearWindow01 RF:WHT LR:BLK/RED RR:GRN/YEL
Doorlocks / Windows Power UnLock REQUIRES DOUBLE PULSE
Convenience
HeadLights YEL + (+) LIGHT SWITCH LowSpeedWipers YEL + (+) AND WHT AT WIPER SWITCH TrunkRelease BLU/BRN - (-) RED JUNCTION BLOCK, RED CONN
Mobile Audio / Video
Battery RED + (+) IGNITION SWITCH HARNESS Accessory01 YEL/VIO + (+) SAME LOCATION AS ING WIRE Ground BLK - (-) RADIO HARNESS
Control Modules
UNDER HOOD
Note:
Tune-Town makes no representation or warranty with respect to the above information including its accuracy, completeness, or its freedom from third parties' proprietary rights. Tune-Town disclaims all liability or responsibility for errors or omissions therein or any decision made by the recipient in reliance thereon. The installer must verify any circuitry with the proper test equipment prior to installation.